Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
- Brake system
- Brakes
General description
+ Diagnostics
Diagnostic table
- Check and adjustment
Stravlivaniye of air from brakes
Check of free height of the brake lever
Adjustment of the light switch of brakes
Check it is superfluous a pedal course
Check of a free wheeling of the brake lever
Check of level of brake liquid
Check of a brake hose and highway
Check of the main cylinder
Check of a brake disk
Check of a brake shoe
Check of a brake boot
Check and adjustment of the parking brake
Washing of hydraulic system of brakes
Check of pressure of liquid (if the car is equipped with LSPV)
Check of operation of the brake amplifier
Specifications - an inhaling torque
Necessary materials for service
Special tool
+ Brake highway/hose / main cylinder of a brake
+ Forward brakes
+ Parking and back brake
+ Anti-blocking brake system (ABS)
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Check and adjustment of the parking brake
Check
|
|
|
|
- Undertake the center of the handle of the parking brake and pull it up with effort of 20 kg (40 pounds).
|
- When the lever of the parking brake will pull up count ratchet marks. There should be 5-7 marks.
- Also check, whether the right and left back wheels are reliably blocked. That it was easier to consider marks, listen to ratchet clicks at a raising of the lever of the parking brake, without pressing the button.
- One click corresponds to one mark. If the quantity of marks does not correspond to the specification, adjust a cable having addressed to procedure of the adjustment described below to receive a necessary course of the parking brake.
|
|
Check, are not damaged and whether heads of tooth of each mark are worn-out. If damages or wear are found, replace the lever of the parking brake. |
|
|
Adjustment
|
|
Before adjustment of a cable be convinced that the following conditions are met:
- In brake system there is no air.
- Course of the brake lever such as it is required.
- The brake lever was pressed several times with effort about 30 kg (66 pounds).
- The lever of the parking brake (1) was several times lifted with effort about 20 kg (44 pounds).
|
|
|
- If the cable of the parking brake is replaced on new, lift the lever of the parking brake several times with effort about 50 kg.
- Back brake blocks are not worn-out beyond the limit, and the mechanism of self-regulation works properly.
- To weaken a cable of the parking brake (2), release самоконтрящуюся a nut (3) till the end of a bolt. Then press the brake lever a little with effort about 30 kg (66 pounds).
- Having convinced that all are observed specified above a condition, adjust a course of the lever of the parking brake, having released or having tightened a lock nut.
|
|
Check, whether jams a brake drum after adjustment. |
Course of the parking brake (when the lever is lifted with effort of 200 N • m (20 kg, 44 pounds) - 5-7 marks. |
|
|
|
