Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation



Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
- Engines
   + Mechanical part of the G16 engine
   + Mechanical part of the J20 engine
   - Engine cooling
      + General description
      + Diagnostics
      + Maintenance
      - Routine maintenance of a vehicle
         Plums of cooling liquid
         Hoses or water pipes of system of cooling
         Thermostat
         Belt of the cooling fan
         The cooling fan and the fan coupling
         Radiator
         Water pump
         The sensor of temperature of cooling liquid of the engine (eats)
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment


5917e1e5



Radiator

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) from the accumulator.
  1. Merge cooling system, having turned off a drain stopper (1) radiator.
  1. At service of vehicles And/t place an oil pan under a radiator (1) and disconnect hoses for And/t liquid (2), (3) from a radiator.
  1. Turn off nuts cooling fans/couplings (1).
  1. Disconnect an inlet hose of a radiator from a radiator.
  1. Remove rasporny bolts of the tank of P/S (1) liquid from a radiator rack.
  1. Remove safety clips of a casing of the fan.
  2. Then remove cooling the fan/coupling and a radiator casing.
  1. Disconnect a water inlet and final hose (1), (2) and a tank (3) hose from a radiator.
  1. Remove a radiator (4).

Check

Check a radiator about a leakage or damage. Straighten pognuty plates if those are.

Cleaning

Clean a forward part of a core of a radiator.

Installation

Repeat dismantle procedure upside-down, without forgetting as follows.

 PERFORMANCE ORDER

  1. Fill system of cooling with the corresponding cooling liquid, having addressed to the Sections Cooling liquid and Washing and filling of system of cooling in this Chapter.
  2. Adjust a tension of a belt of the cooling fan according to technical requirements. Address to the Section Regulation and check of a tension of a belt of the cooling fan in this Chapter.
  3. In vehicles And/t check And/t liquid level, having addressed to the Section liquid Level in Head the Automatic transmission (4 A/T).
  4. After installation check each connection, whether there is no leak.