The device, service, Suzuki Grand Vitara SQ416/SQ420/420WD repair - Service out of a workshop//Suzuki the Grandee of Wetar since 1998 /

Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation



Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
- Transmissions
   + Mechanical transmission (type 1)
   + Mechanical transmission (type 2)
   - Automatic transmission (4 A/T)
      + General description
      + Diagnostics of an automatic transmission
      + Precautionary measures at diagnostics of malfunctions
      + Visual survey
      - Service out of a workshop
         Liquid level
         Liquid replacement
         Hoses of a cooler of oil
         Cable of a throttle of an automatic transmission
         Manual selector
         Gear shifting cable
         Switch (sensor) of a range of transmission
         The sensor of speed on an exit of an automatic transmission
         Interruption switch on demand
         Solenoidal valves
         Switch of change of food \norm
         Tubes of a cooler of oil
      + System of blocking of brakes
      + system Check
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment





Service out of a workshop

Servicing

Liquid level

Level check at normal working temperature

 PERFORMANCE ORDER

  1. Stop the car out of the blue.
  2. Put on the parking brake and put under wheels "boots".
  3. With the lever of a choice of transfer in the situation "P" start the engine.
  4. Warm up the engine while the temperature of liquid will not reach normal working temperature (70-80 ° C/158 – 176°F). As the instruction on check of temperature of liquid, warm up the engine until the counter of temperature of cooling liquid of the engine will not show about "1" above a point "With".
  5. Leave the engine to idle and slowly switch the lever of transfers to situation "L" and back in the situation "P".
  6. At operation of the engine idling pull out oil щуп, wipe it a slice of a pure fabric and return into place.

  1. Again take out oil щуп and check on it liquid level. It should be between marks "COMPLETELY HEATED-UP" and "NEPROGRETY". If it is lower than the mark "NEPROGRETY", add analog of DEXRON - III to level "COMPLETELY HEATED-UP".
1 — oil щуп (G16/J20)

Liquid specification

Analog of DEXRON® - III


  • DO NOT FORCE the ENGINE to WORK ON LIMITING OBORTAKH at check of level of liquid, even after engine start.
  • DO NOT FILL IN it is TOO MUCH. It can bring in formation of foam and liquid loss through сапун that as a result can lead to a soskalzyvaniye and malfunctions of work of an automatic transmission.
  • To finish liquid level from the mark "NEPROGRETY" to a mark "COMPLETELY HEATED-UP" 0.3 liters (0.64/0.53 USA / lmp is required. pints).
  • If the car moved with big loading (for example, with the trailer), level of liquid should be checked approximately in half an hour after its stop.

Level check at room temperature

Check of level of liquid at the room temperature, carried out after repair or liquid replacement before a verifying trip (test drive), represents preparation for level check at normal working temperature. Procedure check same as it is described above. If level of liquid is between marks "COMPLETELY COLD" and «NIZHNY COLD», pass to test drive. And when the temperature will reach level of normal working temperature, again check level of liquid and adjust, if it is necessary.  

1 — oil щуп (G16/J20)