Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation


Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
- Engines
   + Mechanical part of the G16 engine
   + Mechanical part of the J20 engine
   - Engine cooling
      + General description
      + Diagnostics
      + Maintenance
      - Routine maintenance of a vehicle
         Plums of cooling liquid
         Hoses or water pipes of system of cooling
         Thermostat
         Belt of the cooling fan
         The cooling fan and the fan coupling
         Radiator
         Water pump
         The sensor of temperature of cooling liquid of the engine (eats)
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment

5917e1e5


Hoses or water pipes of system of cooling

Removal

For G16 and J20 engines

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) from the accumulator.
  2. Merge cooling system.
  3. Untwist screws on each pipe or weaken clips of hoses and pull the hose end to remove these pipes or hoses.
  4. Remove the case of butterfly valves and an inlet collector

Installation

For G16 and J20 engines  

 PERFORMANCE ORDER

  1. Establish the removed parts as it should be the return to dismantle procedure, without forgetting about the following.
  2. Reliably fasten everyone tightening a bolt.
  1. At installation of a water exhaust pipe (1) to a cylinder head, put hermetic on a carving of a bolt of a pipe and then fasten it (only for the J20 engine). Hermetic "A": 99000-31110.
  1. Fill system of cooling with the corresponding cooling liquid, having addressed to the description in the Sections Cooling liquid and Washing and filling of system of cooling in this Chapter.
  2. Check each part on a leakage.