Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
- Engines
+ Mechanical part of the G16 engine
+ Mechanical part of the J20 engine
- Engine cooling
+ General description
+ Diagnostics
- Maintenance
Check of level of cooling liquid
Service and repair of system of cooling
Washing and filling of system of cooling
Regulation and check of a tension of a belt of the cooling fan
+ Routine maintenance of a vehicle
Necessary service materials
Technical characteristics of the rotating moment of an inhaling
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Washing and filling of system of cooling
|
|
- Uncover a radiator when the engine will cool down. Slowly turn a cover on the left until it will not reach a point of "feet" (Do not press when turn). Wait while pressure will be dumped (a hissing sound points to it), then press a cover and continue to turn on the left.
|
|
In order to avoid a burn do not uncover a radiator, while the engine and a radiator the still hot. Burning liquid and steam can be splashed out under pressure if the cover is removed too early. |
- Having uncovered a radiator, start the engine, the top hose of a radiator (it shows that the thermostat is open and cooling liquid moves on system) will not heat up yet.
- Switch off the engine and open a drain stopper of a radiator to merge cooling liquid.
|
|
- Close a drain stopper (1). Add waters while the system will not be filled, and start the engine while the top hose of a radiator again will not heat up.
|
- Repeat points 3) and 4) several times until merged liquid does not become almost colourless.
- Merge cooling system, and then strong close a drain stopper of a radiator.
- Disconnect a hose from the tank (1). Remove the tank and merge liquid. Rub and clean the tank inside with soap and water. Well wash out it pure water and drain. Establish the tank and a hose into place.
- Add a mix 50/50 ethylene of glikolevy antifreeze of high quality and water in a radiator and the tank. Fill a radiator to a bulk mouth and the tank to a level mark "FULL" (2). Establish a tank cover, having leveled arrows (4) on the tank and a cover.
|
|
1 — a hose from the tank
2 — a mark of high level
3 — a mark of low level |
- Start the engine with an open cover of a radiator until the top hose of a radiator will not heat up.
- At the engine idling, fill in cooling liquid in a radiator to level of a jellied mouth. Establish a radiator cover, having convinced that clips of a cover are leveled with a tank hose.
|
|
|
|
