Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
- Brake system
+ Brakes
+ Brake highway/hose / main cylinder of a brake
+ Forward brakes
- Parking and back brake
+ General description
- Diagnostics
Check and adjustment
Vehicle service
Cable of the parking brake
Brake drum
Brake shoe
Brake cylinder
Back plate of a brake
+ Anti-blocking brake system (ABS)
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Brake cylinder
Removal
|
|
- Execute item of 1-6 procedure of removal of the Section the Brake drum.
- Execute item of 2-4 procedures of removal of the Section the Brake shoe.
- Release a cap nut of the brake highway (or nuts) but only so that liquid did not follow.
|
|
- Remove adjusting boats of the wheel cylinder. Disconnect the brake highway (or highways) from the wheel cylinder and establish a cap of a stopper of a safety valve of the wheel cylinder (1) to the highway let's some liquid pour out.
|
|
|
Survey
|
|
Examine the wheel cylinder, whether there are no wear tracks, cracks, corrosion or damages. |
|
|
Clear components of the wheel cylinder of brake liquid. |
Installation (for not soldered type)
|
|
|
|
- Remove a cap of a stopper of a safety valve from the brake highway and connect the highway (or highways) to the wheel cylinder (1) so that liquid did not proceed.
|
|
|
- Tighten the wheel cylinder on a back plate of a brake (1) according to an inhaling torque. Inhaling torque: bolt of the wheel cylinder (a): 13 N • m (1.3 kg-m, 9.5 pounds foots).
|
- The torque of an inhaling of a cap nut (2) (or nuts) the brake highway (3) which was connected in item 1 above, should correspond to the specification. Inhaling torque: a cap nut of the brake highway (b) — 16 N • m (1.6 kg-m, 12.0 pounds foots).
- Establish a cap of a stopper of the safety valve, removed from the highway, back on a cap of a stopper of a safety valve.
- Then address to item of 1-6 procedure of installation of the Section the Brake shoe.
|
|
|
|
