Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation

Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
- Electric equipment
   + body Electric equipment
   + lighting System
   - Electric equipment system
      + General description
      + Diagnostics
      + the Works made on the car
      - Major maintenance
         - Generator
            Removal
            Installation
            Dismantling [Type 60 A]
            Dismantling [Type 70 A and 80 A]
            Survey [Type 60 A]
            Survey [Type 70 A and 80 A]
            Replacement of brushes
            Assembly [Type 60 A]
            Assembly [Type 70 A and 80 A]
      + Specifications
      Inhaling moments
   + Tools/information for drivers

Assembly [Type 60 A]

PERFORMANCE ORDER

Collect as it should be, opposite to dismantling, having paid attention to the following.
Surely establish brushes in the correct direction and solder wires of brushes and stator contacts.

1 — a stator
2 — a brush
3 — a shchetkoderzhatel
4 — solder
5 — a brush spring

1 — a stator
2 — a brush
3 — a shchetkoderzhatel
4 — solder
5 — a brush spring

Tighten a nut of a pulley of the generator the every moment of an inhaling. Torque of an inhaling (a): 118 N • m (11.8 kg-m, 85.5 pounds foots).

Using a vice, place a pure fabric between a rotor and a vice not to damage a rotor.
Surely hold a rotor in A point. Do not hold him in a zone B, as it insufficiently strong.

1 — a pulley nut
2 — a rotor
3 — a fabric
4 — a vice

Insert brushes in a shchetkoderzhatel, then support brushes, having inserted the corresponding wire from an opening in a back casing.

After rotor installation, remove a wire.
Check and be convinced that marks of combination in a forward and back casing are leveled.
Do not put greasing on the back (rotor) bearing. Completely clean oil if it is in the bearing of a back casing.

1 — a back casing
2 — a wire

After generator assembly, be convinced that the rotor rotates smoothly.