Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
- Electric equipment
+ body Electric equipment
+ lighting System
- Electric equipment system
+ General description
+ Diagnostics
+ the Works made on the car
- Major maintenance
- Generator
Removal
Installation
Dismantling [Type 60 A]
Dismantling [Type 70 A and 80 A]
Survey [Type 60 A]
Survey [Type 70 A and 80 A]
Replacement of brushes
Assembly [Type 60 A]
Assembly [Type 70 A and 80 A]
+ Specifications
Inhaling moments
+ Tools/information for drivers
|
Survey [Type 60 A]
Rotor
|
|
- Using an ohmmeter, check electroconductivity between contact rings of a rotor. If there is no electroconductivity, replace a rotor. Standard resistance: 2.5-2.9.
- Using an ohmmeter, check, whether there is no electroconductivity between a contact ring and the rotor core. If there is an electroconductivity, replace a rotor.
- Check contact rings, whether there is no roughness or a deposit. If they rough or are a deposit, replace a rotor.
|
|
Stator
|
|
- Using an ohmmeter, check electroconductivity of all contacts. If there is no electroconductivity, replace a stator.
- Using an ohmmeter, whether check there is no electroconductivity between contacts of the coil and the stator core. If there is no electroconductivity, replace a stator.
|
|
1 — a stator
2 — stator contact |
|
|
Brush and shchetkoderzhatel
|
|
- Check each brush on wear, having measured its length.
|
|
- If the brush is worn-out to a limit, replace a brush.
- Length of a brush of "a"
- standard: 16 mm (0.63 inches)
- limit: 2 mm (0.08 inches)
|
|
|
Rectifier
|
|
- Using an ohmmeter, check electroconductivity between cases of the top and bottom rectifiers and contact of each diode.
- Check both directions, having changed щупы an ohmmeter. In each case there should be only unilateral conductivity. If result of check unsatisfactory, replace the rectifier.
|
|
- Check unilateral electroconductivity between contacts and three diodes similarly described in item 1.
|
|
|
1 — the rectifier
2 — diode contact |
|
|
Condenser
Check condenser capacity. Condenser capacity: 0.5 µF.
|
|
1 — the rectifier
2 — the condenser |
|
|
