Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
- Electric equipment
+ body Electric equipment
+ lighting System
- Electric equipment system
+ General description
+ Diagnostics
+ the Works made on the car
- Major maintenance
- Generator
Removal
Installation
Dismantling [Type 60 A]
Dismantling [Type 70 A and 80 A]
Survey [Type 60 A]
Survey [Type 70 A and 80 A]
Replacement of brushes
Assembly [Type 60 A]
Assembly [Type 70 A and 80 A]
+ Specifications
Inhaling moments
+ Tools/information for drivers
|
Dismantling [Type 60 A]
|
|
- To facilitate reinstallation, put marks in a forward and back casing before separating them.
|
|
1 — a forward casing
2 — a back casing
3 — marks for combination |
|
|
- Remove casing bolts from the generator.
|
- When the lever is inserted between the core of a stator and a forward casing, divide the generator into forward and back parts.
|
|
1 — a back casing
2 — the stator core
3 — a forward casing
4 — the lever |
|
|
1 — a back casing
2 — the stator core
3 — a forward casing |
- Release a pulley nut by means of a vice and remove a pulley.
|
|
- Using a vice, place a pure fabric between a rotor and a vice not to damage a rotor.
- Surely hold a rotor in A point. Do not hold him in a zone B as it insufficiently strong.
|
- Remove a rotor from a forward casing.
|
|
1 — a pulley neck
2 — a rotor
3 — a fabric
4 — a vice |
- Removing the forward bearing, remove screws of the holder of the bearing and the holder.
|
|
1 — a forward casing
2 — the screw of the holder |
- Removing the back bearing, an oil hydraulic press.
|
|
1 — the back bearing
2 — a hydraulic press
3 — the general rod
4 — the general tool |
- Remove three screws and a terminal nut of "B" of the generator.
|
|
1 — the screw
2 — a terminal nut of "B"
3 — the plug "B" |
- Disconnect contacts of a stator and remove a stator from a back casing and regulator assembly.
|
|
1 — stator contact (solder) |
- To remove a brush, uncover the holder the holder of a brush and then disconnect a brush wire from the regulator plug, using a soldering iron.
|
|
1 — the holder of a brush
2 — solder
3 — a brush spring |
|
|
|
|
