Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
- Steering
+ Suspension bracket, wheels and tires
+ Adjustment of corners of installation of wheels of a forward suspension bracket
+ power steering System
- Steering wheel and steering column
- Steering wheel and steering column not equipped with a safety cushion
General description
+ Diagnostics
- Service out of a workshop
Steering wheel
Podrulevye switches
Steering column (at not a cabriolet)
The top shaft of a steering (at not a cabriolet)
Steering column (at a cabriolet)
Steering lock (ignition switch)
Bottom shaft of a steering
Check of a steering column on existence of damages at failure (at a cabriolet)
Check of a steering column and the top shaft of a steering on existence of damages at failure (at not "cabriolet")
Lever of an adjustable unblocking of a steering column
Specifications of the moment of an inhaling
Special tool
+ the Steering wheel and a steering column with a safety cushion
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Steering column (at not a cabriolet)
|
|
When the steering column is removed from the car, it is very easy for damaging. If it to drop vertically, the steering shaft can break or can weaken plastic pins which regulate length of a column; if on it to lean, it can be bent or deformed. Any of the listed damages can worsen udaropogloshchayushchy properties of a column. Weakening fixing bolts and nuts of a steering column, be convinced that the steering column and the top steering shaft are disconnected. If before weakening of fixing bolts and nuts a steering column and the top steering shaft not to separate, it can damage the top coupling and a fixing bracket of the top steering shaft. |
|
|
At carrying out service of a steering column or any knots established on it it is necessary to remove a steering wheel. But if the steering column acts in film to provide only access to toolbar components, the steering wheel can be not removed from a column. |
Removal
|
|
- Disconnect "minus" (–) a battery cable.
- Remove a steering wheel and podrulevy switches if it is required. See in this Chapter Sections the Steering wheel and Podrulevye switches.
- If the steering wheel and\or podrulevy switches remain on a place, execute the following manipulations:
- Turn a steering wheel so that forward wheels of the car looked directly forward.
- Turn the ignition switch in the situation "LOCK" and pull out a key.
|
|
Uncover a steering column (1). |
- Disconnect all cables of the following knots:
- Contact spiral and podrulevy switches
- Ignition switch
- Elements of anticreeping system (if are available).
|
|
- Remove a bolt (1) and a nut (2) top couplings of the top steering shaft.
|
|
|
- Remove a steering column (1), fixing bolts (2 pieces) (2) and nuts (2 pieces) (3).
|
|
|
- If there is a cable of blocking of the switch (key) (1), disconnect it from the ignition switch, having turned the ignition switch in the situation "ACC".
|
- Remove a steering column from the car.
|
|
Survey
Check serviceability of a steering column and existence of damages as it is described in this section in head «Check of a steering column and the top shaft of a steering on existence of damages at failure».
Installation
|
|
After a tightening of fixing bolts of a steering column it is necessary to tighten bolts of the coupling of a steering shaft. |
|
|
- Be convinced that the provision of forward wheels and a steering wheel correspond to rectilinear movement of the car.
|
|
- If there is a cable of blocking of the switch (key) (1), connect it to the ignition switch, having turned the ignition switch in the situation "ACC". Then turn the ignition switch in the situation "LOCK".
|
|
|
- Combine a point of "A" of a steering column (1) with an opening of a nut of "B" of the top coupling of the top steering shaft. Then connect the top coupling of the top steering shaft.
|
|
|
- Establish a steering column (1) contact top party of the bottom shlitsa to fixing bolts. Tighten the bottom fixing nuts (3) helmsman of a column, and then the top fixing bolts (2) to the specified values of the moment of an inhaling. Inhaling moment: fixing bolts and nuts of a steering column — 25 N • m (2.5 kg-m, 18.0 pounds foots).
|
|
|
- Establish a bolt (2) top couplings of the top steering shaft and a nut (1). Tighten a nut (1) top coupling of the top steering shaft till the specified moment of an inhaling. Inhaling moment: a nut of the top coupling of the top steering shaft (a) — 23 N • m (2.3 kg-m, 17.0 pounds foots).
|
- If podrulevy switches were removed, establish them as it is described in this Chapter in Podrulevye's Section switches.
- Connect all cables which were disconnected at removal of a steering column.
|
|
- Establish a cover of an opening of a steering column (1).
|
- If the steering wheel was removed, establish it as the Steering wheel is described in this Chapter in the Section.
- Connect "minus" (–) a cable to the battery.
|
|
|
|
