Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
- Transmissions
- Mechanical transmission (type 1)
System description
Diagnostics
- Service out of a workshop
Oil for a transmission
Gear shifting lever
Illumination switch
Back fixture of the engine
Transmission removal
Transmission installation
The case extension piece (for model with a drive on two wheels and the G16 and J20 engine)
Oil epiploon of the case extension piece (for model with a drive on two wheels and the G16 and J20 engine)
+ Mechanical transmission (type 2)
+ Automatic transmission (4 A/T)
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Illumination switch
|
|
Refrain from work, while the central exhaust pipe hot. |
Removal and installation
|
|
At replacement of the switch be careful, that the dust did not get to a transmission through a switch opening. |
|
|
- Lift the car.
- Remove a hitch (and) switch wires.
Type 1 and type 2
|
|
1 — a hitch of the switch of illumination
2 — the forward driveshaft |
Type 3
|
|
1 — a hitch of the switch of illumination
2 — the forward driveshaft |
- Replace the switch of illumination (1), connect and fix, as was in a starting position.
- Inhaling moment:
- (a): 20 N • m (2.0 kg-m, 14.5 pounds foots) (Type 1)
- (a): 45 N • m (4.5 kg-m, 32.5 pounds foots) (Type 2 and type 3)
- After replacement of the switch of illumination check serviceability of operation of the switch, having turned the ignition key in the situation "INCL." (ON), and transfer having switched in the provision of a backing. After check of operation of the switch, switch off it.
Type 1
|
|
2 — the central exhaust pipe |
|
|
Check
|
|
- Open a latch and disconnect a hitch of the switch of illumination.
|
|
- Operation of the switch of illumination (1) can be checked.
|
- The chain should become isolated on its terminals only when the lever of switching is in the provision of a backing.
- On termination of check attach a hitch and clip wires how they were connected initially.
|
|
At replacement of the switch be careful, that the dust did not get to a transmission through a switch opening. |
|
|
|
|
