Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation


Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
- Transmissions
   - Mechanical transmission (type 1)
      System description
      Diagnostics
      - Service out of a workshop
         Oil for a transmission
         Gear shifting lever
         Illumination switch
         Back fixture of the engine
         Transmission removal
         Transmission installation
         The case extension piece (for model with a drive on two wheels and the G16 and J20 engine)
         Oil epiploon of the case extension piece (for model with a drive on two wheels and the G16 and J20 engine)
   + Mechanical transmission (type 2)
   + Automatic transmission (4 A/T)
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment

5917e1e5


Service out of a workshop

Oil for a transmission

Check and replacement

 PERFORMANCE ORDER

  1. Before replacement or check of oil be convinced that the engine is switched off, and horizontally lift the car.
  2. At the lifted car check level and leakage of oil. If leak is found, eliminate it.
  3. Merge old oil and pour the specified quantity (approximately to an urovnevy opening) the new specified oil.
  • It is urgently recommended to use SAE 75W-90 oil.
  • When lifting car for any other, than replacement of oil, service, check leakage of oil and a condition of hoses сапуна.
  • If in the merged oil there is a water or a rust, check a hose сапуна and a transmission and transfer casing.
    • Oil specification:
      • oil brand: API GL-4
      • viscosity: SAE 75 W-85, 75 W-90 or 80 W-90
      • oil capacity: 1.5 liter (3.2/2.6 USA/Imp. pints)
Scheme of viscosity of society of automobile engineers (USA).
  1. Tighten a drain stopper (1) and a level stopper / a bulk opening (2), as shown below, previously put hermetic on a carving. “A”: hermetic 99000-31110. Moment of an inhaling (a): 23 N • m (2.3 kg-m, 17.0 pounds foots).

  • It is impossible to fill in oil of a transmission through a part of the lever of gear shifting.
  • Do not weaken and do not remove a bolt of a shaft of an intermediate gear wheel of a backing (3).