The device, service, Suzuki Grand Vitara SQ416/SQ420/420WD repair - Check of operation of the hydraulic ABS block//Suzuki the Grandee of Wetar since 1998 /

Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation



Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
- Brake system
   + Brakes
   + Brake highway/hose / main cylinder of a brake
   + Forward brakes
   + Parking and back brake
   - Anti-blocking brake system (ABS)
      + General description
      - Diagnostics
         Precautionary measures at diagnostics of problems
         Table of diagnostics of malfunctions of ABS
         Checks
         Codes of diagnostics of malfunctions
         System scheme
         Tables
         Check of codes of diagnostics of malfunctions (KDN)
         Vehicle service
         Check of operation of the hydraulic ABS block
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment





Check of operation of the hydraulic ABS block

Using the SUZUKI scanner

 PERFORMANCE ORDER

  1. Check, whether in a good condition the main brake systems besides ABS.
  1. Check that tension of the battery 11 B or above.
  1. Using an alarm lamp of ABS, check, whether it is revealed deviations in ABS work. Address to the Section Check of codes of diagnostics of malfunctions (KDN) in this Chapter.
  2. Lift a vehicle.
  3. Establish transmission in neutral situation and release the parking brake.
  4. Manually gradually turn each wheel to check, whether there is no brake jamming. If the brake jams, correct.
  1. Connect the SUZUKI scanner to the socket of a data link (DLC) (1) at the switched-off ignition switch. Special tool: (A) — SUZUKI scanner.
  1. Include an ignition switch and check operation of the solenoid in a mode "Other checks" of SUZUKI scanner (MISC.tests).
  1. Check, that each wheel rotated, only at the dumped pressure of brake effort (about 0.5 seconds).
  2. If in this step malfunction is found, replace hydraulic block/assembly of the module of management.