Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
- Suspension bracket
+ Forward suspension bracket
- Back suspension bracket
General description
+ Diagnostics
- Service out of a workshop
Shock-absorber
Cylindrical spring
Bottom draft
Top draft
Lateral draft
Zadny Bridge and wheel bearing
Internal oil epiploon of the back bridge
Case of the back bridge
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Cylindrical spring
Removal
|
|
- Lift the car and remove a back wheel.
|
|
- Floor jack (2) prop up the case of the back bridge (1).
|
|
|
- Disconnect an eye of a cable of a parking brake (1) from a frame of the chassis and the plug (3) from a cross-piece (2).
|
|
|
- Remove the bottom fixing bolt (1) shock-absorber.
|
|
|
- Remove plugs of the sensor of speed of a wheel (1) from the top draft (2) and the bridge case if there is a system of anti-blocking of brakes of ABS.
|
|
|
- For the right side – remove an E-shaped ring of fixing of a brake tube from a cross-piece and disconnect a hose сапуна from the bridge case.
|
- Gradually lower the case of the back bridge until then when it will be possible to remove a cylindrical spring.
- Remove a cylindrical spring.
|
|
Installation
|
|
|
|
- Establish a cylindrical spring (3) in a nest of a spring (2) on the case of the bridge (1), and then lift the bridge case.
|
|
|
At installation of a cylindrical spring combine the spring end with a step part (4) nests of a spring of the back bridge. |
- Establish the bottom bolt of the shock-absorber. A nut do not tighten.
|
|
1 — the body center
2 — outer side of a body |
- Establish the plug of the sensor of speed of a wheel (if is available) and an E-shaped ring and attach a hose сапуна to the bridge case.
|
|
- Attach an eye of a cable (1) to a frame of the chassis (4) and the plug (3) to a cross-piece (2). Clean a jack from under the bridge case.
|
|
|
- Establish a wheel and tighten wheel nuts to the specified value of the moment of an inhaling. Inhaling moment: nut of a wheel (a): 100 N • m (10.0 kg-m, 72.5 pounds foots).
|
- Lower the lift and tighten the bottom nut of the shock-absorber to the specified value of the moment of an inhaling. Inhaling moment: Bottom nut of the shock-absorber: (b) — 100 N • m (10.0 kg-m, 72.5 pounds foots).
- For a tightening of the bottom nut see in this Chapter the Note in the Section Shock-absorber (Installation).
|
|
1 — the body center
2 — outer side of a body |
|
|
|
|
