Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
- Engines
- Mechanical part of the G16 engine
+ General description
- Routine maintenance
Compression check
Check of depression of the engine
Check of pressure of oil
Klapanny gap
Filtering element of the air filter
Cover of a head of cylinders
Case of butterfly valves and inlet collector
Collector of the fulfilled gases
Belt of a drive of the gas-distributing mechanism and the tension device for a belt
Oil pan and grid of the oil pump
Oil pump
Valve yoke, axis of yokes and cam-shaft
Valves and head of the block of cylinders
+ piston Rod, piston rings, rods and cylinders
Special tool
Necessary service materials
Technical characteristics of the rotating moment of an inhaling
+ Mechanical part of the J20 engine
+ engine Cooling
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Routine maintenance
Compression check
Pressure of compression on all four cylinders is checked as follows.
|
|
- Warm up the engine.
- After a warming up stop the engine.
|
|
After a warming up of the engine put the gear shifting lever on "Neutral" (for And/t models put the gear shifting lever on a range of "R"), both establish the parking brake and block driving wheels. |
|
|
- Disconnect a connector of a bunch of wires of a fuel injector.
|
|
|
- Remove knots of the coil of ignition and all spark plugs relating to a spark plug and the unit of the coil of ignition in Head System of ignition.
|
|
|
- Establish the special tool for compression measurement in cylinders (компрессиметр) in a spark plug opening.
- Special tool:
- (А): 09915-64510-001
- (В): 09915-64510-002
- (С): 09915-64530
- (D): 09915-67010
|
|
|
- Switch off coupling (to reduce initial load of the engine) for M/t models, and press a pedal of management of supply of fuel against the stop completely to open a butterfly valve.
|
- Start the engine with completely charged accumulator and read the maximum instrument of pressure on a kompressimeter.
компрессиметре
|
|
To measure pressure of compression, start the engine, at least, on 250 revolutions per minute, by means of completely charged accumulator. |
Pressure of compression
|
|
Pressure of compression
|
|
The normal
|
1400 kPas (14.0 kg/cm2, 199.0 пси)
|
|
The limiting
|
1200 kPas (12.0 kg/cm2, 170.0 пси)
|
|
The maximum deviation between two cylinders
|
100 kPas (1.0 kg/cm2, 14.2 пси)
|
- Execute item 5-7 on each cylinder to read four instruments.
|
|
- After check insert spark plugs and knots of the coil of ignition and reliably connect a connector of a bunch of wires of a fuel injector.
|
|
|
|
|
