.

Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation



Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
- Transfer
   General description
   + Diagnostics
   - Service out of a workshop
      Oil of a transfer case
      Gear shifting lever
      Switch of transfer of the all-wheel drive car
      + Oil epiploons of transfer
      Sensor of speed
      Back fixture of the engine
      Transfer module
      Removal
      Installation
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment





Gear shifting lever

Removal

 PERFORMANCE ORDER

  1. Remove covers (1) from the central console boxes.
  1. Remove the top cover (2) back central console boxes.
  2. Remove 6 bolts, and then a back central console box.
  3. Uncover a casing.
  1. Lift a casing No. 3, a casing No. 2 (1).
  1. Remove a casing clip, and then lift a casing No. 1 (2) from the case of the lever of switching of a transmission (3).
  2. Fingers press down a cover of the case of gear shifting (4), turn it counter-clockwise and pull out the lever of gear shifting (5).

Check

 PERFORMANCE ORDER

  1. Check the lower part of the lever of gear shifting and an adjusting leaf of the lever on excessive wear.
  2. Check a casing on damages.
  3. If necessary, replace or correct.
  1. If adjusting bolts (1) lever of switching are replaced or drawn, tighten them to the specified value of the moment of an inhaling.
  1. At replacement of adjusting bolts (1) lever of switching the carving clamp for carving blocking is required. “B”: clamp of a carving 99000-32110. Moment of an inhaling (a): 17 N • m (1.7 kg-m, 12.5 pounds foots).
  2. Put greasing on rotating parts and a nest, then establish the gear shifting lever. “A”: greasing 99000-25010.
  1. Establish the lever of gear shifting (2) in the lever case.
  1. Having pressed a hand down a cover of the case of the lever of gear shifting (1), turn it (1) clockwise.
  1. Establish a casing No. 1 (1) from within salon and reliably fix it a new clip (2).
  1. Establish a casing No. 2 (2) with a cover of a casing (3) and an arm of a console box (1).
  1. Establish a console box.

Be convinced that the extending end of a casing No. 3 was combined with a console box.


  1. Having combined a casing No. 3 (1) with covers (2), establish covers (2) on the central console boxes. (a): 17 N • m (1.7 kg-m, 12.5 pounds foots).