Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation

Suzuki Grandee of Wetar
- General information
   + Precautionary measures
   Main precautionary measures
   Precautionary measures at work with the catalyst
   Precautionary measures at service of electric chains
   + Procedure of check of electric chains
   Interrupting or weak connection
   Precautionary measures at installation of means of mobile communication
   + Identification information
   Warning, warning and information stickers
   Places of lifting of the car
   The list of the reductions which are using in this management
   + Metric information
   Standard moments of inhalings
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment

Places of lifting of the car

Before a car raising on the lift, always estimate it on an equilibrium state.
Balance of the car can be broken depending on spare parts which should be removed.
Before a car raising, check, that paws of the lift did not concern brake, fuel pipelines, arms or other parts.
When using the frame lift, make lifting (lift paws from the left and right parties are symmetrically rather central axis of the car). Lift the car while wheels slightly will not come off the earth, and make sure that it will not fall by its rocking extensively. Work can be begun only after successful passing of check.
Do not forget to fix the lift, after a car raising.

Lift use

1 — a forward point of lifting
2 — a back point of lifting
3 — in front of the car

At a podnimaniye of a lobby or a back part of the car on a jack, establish a jack strictly on the center of a stretcher of a forward suspension bracket or the back bridge respectively.

Never lift the car on a jack for suspension bracket details (i.e. the stabilizer etc.) or for the bottom, they can be deformed.
At a podnimaniye only a lobby or a back part of the car, with a view of safety, check that wheels standing on the earth are blocked.
After the car is lifted, fix it retaining racks. It is very dangerous to carry out any works on the car lifted on a jack.

Use of a floor jack

1 — a forward suspension bracket
2 — a case of the back bridge

For works with the forward or back parts of the car lifted on a jack, establish props under a stretcher so that the body was reliably supported. Then, with a view of safety, make sure that the frame of the chassis will not move down from struts, and that the car is rigidly supported.

A — the front view
B — the rear view
1 — a support