Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
- Coupling
General description
Diagnostics
- Service out of a workshop
Liquid check
Height of a pedal of coupling
Free wheeling of a pedal of coupling
Tube and liquid hose for coupling
Main cylinder of coupling
Cylinder of work of coupling
+ module Repair
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Tube and liquid hose for coupling
Removal
|
|
Avoid liquid hit on the painted surface. |
|
|
|
|
- Remove a dust and dirt from each shlangovy connection (2) and tubes (1) which will be separated, and clear round a tank cover.
|
- Gather liquid a syringe or something similar.
- Disconnect a tube for liquid from a hose.
|
|
To disconnect a tube (1) from a hose (2), separate them by means of a key for razvaltsovanny nuts (4) and a wrench (3) so that not to overwind them. |
|
|
Check
|
|
Check a tube (1) and a hose (2) on dents, excesses, cracks, dirt and a dust. If results of check are unsatisfactory, replace. |
Installation
Execute removal procedure in return sequence, paying attention to the following:
|
|
Tighten razvaltsovanny nuts (3) to the specified value of the moment of an inhaling. Moment of an inhaling (a): 16 N • m (1.6 kg-m, 11.5 pounds foots). |
|
|
|
|
- For an air stravlivaniye only from the main cylinder, it is necessary for removing from the car.
- Procedure of removal and installation of the main cylinder and stravlivaniye of air is described in the Section the Main cylinder of coupling.
- Avoid liquid hit on the painted surfaces.
- Watch, that a tube (1) and a hose (2) did not concern the car or other parts.
- Reliably establish all clips.
- Reliably establish an E-shaped ring (3).
- After installation check a free wheeling of a pedal of coupling and pit air from system.
- Check, whether there is no leakage of liquid.
- Add liquid approximately to MAX mark (maximum) on the tank.
|
|
|
|
