Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
- Start system
+ General description
- Diagnostics
Block repair
Analysis
Assembly
Survey
Work check
Specifications
Type of 0.9 kV
Necessary materials
Special tool
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Work check
|
|
Each check should be carried out within 3-5 seconds that the coil did not fuse. |
Retraction check
|
|
- Connect the battery to the electromagnetic switch as shown below.
- Check that the piston and a gear come to light.
- If the piston and a gear do not move, replace the electromagnetic switch.
|
|
Before check, disconnect a wire wire from a conclusion of M. |
|
|
1 — 'S' conclusion
2 — a conclusion of 'M'
3 — a wire conclusion (the switch on the motor)
4 — a conclusion 'In' |
|
|
Keeping check
|
|
|
|
- At connection as it is specified above with the put-forward piston, disconnect a negative wire from a conclusion of 'M'.
|
- Check that the piston and a gear remain outside.
- If the piston and a gear come back back, replace the electromagnetic switch.
|
|
Check of return of the piston and gear
|
|
Disconnect a negative wire conclusion from the switch case. Check that the piston and a gear come back inside. If the piston and a gear do not come back, disassemble and check a starter. |
Work check without loading
|
|
- Connect the battery and the ampermeter to a starter as shown.
|
|
- Check that the starter rotates smoothly and constantly, and the gear moves outside. Check that the ampermeter shows a current as it is specified. The specified current: 90 A MAX. at 11 Century.
|
|
|
Use thicker wires and completely tighten each conclusion. |
|
|
|
|
