Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
- Start system
+ General description
- Diagnostics
Block repair
Analysis
Assembly
Survey
Work check
Specifications
Type of 0.9 kV
Necessary materials
Special tool
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Assembly
|
|
- It is not authorized to wash out, regulate or assort the shock-absorber (a disk of the coupling of coupling).
- New bearings without greasing were greased, when were delivered as spare parts. Do not wash out a maslorastvoritel and do not grease with other lubricant substance.
|
|
|
- Check components (see. Survey) also replace on new if necessary.
- Put greasing (see. Starter).
- Establish an anchor on a collar.
- Establish brushes and springs of brushes on a shchetkoderzhatel.
- Establish a shchetkoderzhatel on an anchor, squeezing out 4 brushes outside.
|
|
1 — a brush
2 — a brush spring
3 — a shchetkoderzhatel |
- Establish a back sleeve and then a cap of a back bracket.
- Establish a back bracket.
- Tighten screws of a shchetkoderzhatel.
|
|
1 — a back bracket
2 — screws of a shchetkoderzhatel |
- Establish assembly of the obgonny coupling on a shaft - a gear wheel, paying attention to the direction of installation of a lock ring of a gear.
|
|
1 — the obgonny coupling
2 — a lock ring of a gear
3 — a persistent ring
4 — a shaft gear wheel |
- Insert shaft assembly into a forward casing, position of the lever.
|
|
1 — lever assembly
2 — the lever |
- Establish laying so that cuts in it were combined with openings for through bolts in a forward casing.
- Establish a plate and rubber consolidation in a forward casing.
|
|
1 — laying
2 — planetary transfer
3 — an opening for a bolt
4 — rubber consolidation |
- Put greasing on a ball and establish a ball in a shaft opening.
- Establish a collar, an anchor, a shchetkoderzhatel and a back bracket in a forward casing, having combined the marks put before removal.
- Tighten through bolts.
|
|
1 — bolts
2 — reducer assembly |
- Establish assembly of the electromagnetic switch and a protector (if is). Connect a wire (to the motor) to a switch conclusion.
- After the completion of assembly inspect work.
|
|
1 — the electromagnetic switch
2 — a protector |
|
|
|
|
