The device, service, Suzuki Grand Vitara SQ416/SQ420/420WD repair - Check of a rim, a nut and the bearing//Suzuki the Grandee of Wetar since 1998 /

Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation



Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
- Suspension bracket
   + Forward suspension bracket
   - Back suspension bracket
      General description
      - Diagnostics
         Diagnostic table
         Shock-absorber check
         Check of the bottom draft, top draft, lateral draft
         + Check of the case of the bridge and cylindrical spring
         Check of a stopper of the bearing and internal oil epiploon of the bridge
         Check of a rim, nut and bearing
      + Service out of a workshop
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment





Check of a rim, nut and bearing

 PERFORMANCE ORDER

  1. Check each rim on existence of dents, deformations and cracks. It is necessary to replace strongly damaged disk.
  1. Check an inhaling of nuts of a nave of a wheel and, if necessary, tighten to the specified value of the moment of an inhaling. Inhaling moment: a nut of a wheel (a) — 100 N • m (10.0 kg-m, 72.5 pounds foots).
  1. Check wheel bearings on wear. To measure люфт, remove from the wheel middle a cap and put the device with the dial to the bridge center. Border люфта wheel bearing: 0.8 mm (0.03 inches).
  1. If measurement exceeds this border, replace the bearing.
  1. Rotating a wheel, check the bearing on noise and smoothness of rotation. If defect is found, replace the bearing.