Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation

Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
- Steering
   + Suspension bracket, wheels and tires
   - Adjustment of corners of installation of wheels of a forward suspension bracket
      - General information
         Convergence of forward wheels
         Disorder of forward wheels
         Custer
         Preparation for adjustment of corners of installation of wheels of a forward suspension bracket
         Adjustment of a corner of a convergence of forward wheels
         Adjustment of a corner of disorder and kaster
         Angle of rotation of wheels
         Lateral sliding of wheels (standard)
   + power steering System
   + Steering wheel and steering column
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment

Preparation for adjustment of corners of installation of wheels of a forward suspension bracket

Complaints to controllability and vibration not always happen are caused by the wrong installation of corners of wheels. It is also necessary to check tires on wear and on their compliance with recommended by plant the manufacturer. "Maintaining" is a spontaneous withdrawal of the car from rectilinear movement in any party without pressure from a wheel. Head the Steering, a suspension bracket, wheels and tires of this Management includes procedure of identification of this problem.

Before convergence adjustment, the following checks should be executed to exclude influence of other factors on correctness of reference values and on adjustment:

PERFORMANCE ORDER

Check, that in all tires there was an identical pressure and approximately identical wear of drawing of a protector.
Check spherical connections on люфты. Check tips of steering drafts. At detection люфтов, they should be eliminated before adjustment.
Check disks and tires on excessive wear.
Check the car on a prosedaniye; if it does not keep within limits, it is necessary to eliminate it before convergence adjustment.
Check on люфты the rotary lever.
Check the stabilizer of cross-section stability on rigidity of fastenings.
If additional cargo in the car (for example, a box with tools) is there constantly, adjustment should be carried out together with cargo.
To check a condition of the adjusting stand and to follow instructions of the producer.
In independence of the used equipment, the car should stand on a horizontal surface of a lobby and a back part and should be perpendicularly.

To prevent possibility of incorrect reading of initial corners of disorder or a kaster, a lobby (or back) the part of the car needs to be lifted and lowered several times before inspection.