Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation



Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
- Ignition system
   - Ignition system for the G16 engine
      + General description
      + Diagnostics
      - Vehicle service
         Check of a spark of ignition
         Check of time of an advancing of ignition
         Wire of a high voltage
         Assembly of the coil of ignition (igniter and ignition coil)
         Spark plug
         The resistor an ignition advancing (if it is established)
         CMP sensor
         Reducer
      Specification, inhaling torque
      Special tool
   + ignition System for the J20 engine
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment





The resistor an ignition advancing (if it is established)

Removal

 PERFORMANCE ORDER

  1. At the disconnected ignition, remove ECM (or PCM).
  2. Remove the resistor of an advancing of ignition (2).
1 — the reducer
2 — the resistor of an advancing of ignition

Survey

Measure resistance of the resistor of an advancing of ignition, using an ohmmeter.

Depending on number on the resistor of an advancing of ignition, value of the resistor change as follows (see tab. below).


1

0

6

980 — 1020

2

80 — 84

7

1.47 — 1.53

3

157 — 163

8

2.16 — 2.24

4

265 — 274

9

3.53 — 3.67

5

421 — 439

10

6.08 — 6.32

N

666 — 694 i

11

11.8 — 12.2

If result of check not satisfactory, replace the resistor of an advancing of ignition.

Installation

For installation execute removal procedure upside-down.