Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
- Ignition system
- Ignition system for the G16 engine
+ General description
+ Diagnostics
- Vehicle service
Check of a spark of ignition
Check of time of an advancing of ignition
Wire of a high voltage
Assembly of the coil of ignition (igniter and ignition coil)
Spark plug
The resistor an ignition advancing (if it is established)
CMP sensor
Reducer
Specification, inhaling torque
Special tool
+ ignition System for the J20 engine
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Assembly of the coil of ignition (igniter and ignition coil)
Removal
|
|
- Disconnect the coupling of the coil of ignition.
|
|
- Disconnect a wire of a high voltage (3) from the coil of ignition (2).
|
- Remove a bolt of the coil of ignition (1), and then extend coils of ignition (2).
|
|
Survey
|
|
Check, whether there is no for damages, a permission and corrosion of conclusions. If result of check unsatisfactory, replace the coil of ignition (1). |
Installation
|
|
|
|
- Establish the coil of ignition (2).
|
- Tighten a bolt of the coil of ignition (1), and then connect the coupling of the coil of ignition.
- Connect a wire of a high voltage (3) to the coil of ignition (2), holding its cap.
|
|
|
|
