Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
- Windows, mirrors, locks and security measures. Immobilizer
- Windows, mirrors, locks and security measures
+ General description
+ Diagnostics
- Maintenance
+ Cleaner and windscreen washer
Screen wiper electromotor
Pump of a stekloomyvatel
Control system of electrowindow regulators
System of blocking of locks (if the system is not established, allowing to get to car salon without a key)
+ System of blocking of doors with a radiobrelka (if the system is established, allowing to get to car salon without a key)
System of the electric drive of mirrors
Heater of lateral mirrors (if it is equipped)
Heater of a forward seat (if it is equipped)
+ Immobilizer
+ Electric equipment
|
Pump of a stekloomyvatel
|
|
|
|
- Connect battery conclusions «+» and «-» to the corresponding plugs of the pump to check productivity of the pump.
|
- Productivity of the pump: more than 1 l/minutes.
|
|
1 — a tank of a stekloomyvatel |
- Disconnect "weight" from the storage battery.
- Disconnect the socket from the combined switch.
- Put the cleaner switch in the situation "INT".
- Expose intensity adjustment in the situation "FAST".
|
|
- Connect a positive conclusion of the battery to the B3 plug and a negative conclusion to the plug "E".
|
- Connect a positive conclusion of the voltmeter to the plug «+1» and a negative conclusion to the plug "E".
- Check, that the voltmeter showed level of a charge of the battery (10-14 In).
|
|
a — low intensity
b — high intensity
Е — a negative conclusion to the plug |
|
|
- Connect among themselves As and B3 plugs by means of a connecting wire. Then connect other end of the connecting wire connected to the B3 plug, to the plug "E". Pay attention to power failure to 0. In, right after connection of a connecting wire from the B3 plug to the plug "E". Then tension is restored to tension of a charge of joint stock bank (10-14 In) during time specified in the table below.
|
|
|
Connected operations of a stekloomyvatel
|
|
- Disconnect "weight" from the storage battery.
|
|
- Disconnect the socket from the combined switch.
|
- Make sure that the switch of operating modes of forward yard keepers is in situation "is switched off".
|
|
- Connect a positive conclusion of the battery to the B3 plug and a negative conclusion to the plug "E".
|
- Connect a positive conclusion of the voltmeter to the plug «+1» and a negative conclusion to the plug "E".
- Pull the switch of operating modes of a cleaner and check that tension changes.
|
|
and — the stekloomyvatel is included |
|
|
|
|
