Suzuki Grand Vitara SQ416/SQ420/420WD

since 1998 of release

Repair and car operation

Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
- Ignition system
   + ignition System for the G16 engine
   - Ignition system for the J20 engine
      + General description
      + Diagnostics
      - Vehicle service
         Check and adjustment of time of an advancing of ignition
         Assembly of the coil of ignition (igniter and ignition coil)
         Spark plug
         CMP sensor
      Specification, inhaling torque
      Special tool
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment


CMP sensor

It is forbidden to assort a sensor. If any malfunction is found, replace it as the whole assembly.



  1. Disconnect the coupling of a CMP sensor (2).
  2. Remove CMP (1) sensor, having removed a bolt (ы) (3).
J20 engine.


After CMP sensor installation, adjust time of an advancing of ignition (see. Check of time of an advancing of ignition in this Chapter).


  1. Establish a new O-ring (2), having dripped engine oil on CMP a sensor (1).
  1. Establish a CMP sensor (1) on a cam-shaft (3).
  2. Insert at installation an emphasis of the coupling of a CMP sensor (2) into cam-shaft sockets. An emphasis of the coupling of a CMP sensor (2) is displaced, therefore if an emphasis is not inserted into sockets, turn the sensor CMP-axis on 180 degrees and try again.

J20 engine

A — socket shift
3 — a cam-shaft
  1. Tighten bolts of CMP of a sensor (3). Inhaling torque: bolt (ы) CMP sensor: 15 N • m (1.5 kg-m, 11.0 pounds foots).
  2. Connect the coupling of a CMP sensor (2).

J20 engine

1 — a CMP sensor
2 — the CMP sensor coupling
3 — bolts