Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
- Fuel system
- Current maintenance of a vehicle
Fuel pump
Fuel filter
Fuel wires
Cover of a jellied fuel mouth
Fuel tank
Technical characteristics of the rotating moment of an inhaling
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
+ Electric equipment
|
Current maintenance of a vehicle
Preventions
|
|
Always observe the following cautions before starting service of fuel system of any type. |
- Disconnect a negative cable from the accumulator.
- DO NOT SMOKE, and hang up the plate "NOT to SMOKE" near a workplace.
- Always hold near at hand the CO2 fire extinguisher.
- Work in well aired room, far away from open fire (such as a gas heater).
- Carry goggles.
- To dump pressure паров fuel evaporations in a fuel tank, uncover a jellied fuel mouth a mouth, and then establish it back.
- As submitting топливопровод still is under a high pressure of fuel even after engine shutdown, direct untwisting or a detachment striking топливопровода can cause emission of a dangerous stream of fuel in an untwisting or detachment place. Before turning off or disconnecting submitting топливопровод do not forget to dump pressure of fuel.
- After a detachment топливопровода a small amount of fuel can flow out. To reduce risk of a personal travmirovaniye, cover a fitting which you are going to disconnect, shop rags. Put this rags in the container special for it after the detachment is complete.
- Pay attention to that connections of fuel hoses differ for each type of a pipe. Be convinced that you connect and fix a clip each hose correctly, addressing to the below-mentioned.
- Each time when you perform the work demanding lifting of a vehicle, check clips of fuel hoses on rust existence.
|
|
By means of a short pipe insert a hose until it will not reach a joint of pipes, as shown.
1 — a hose
2 — a pipe
3 — a clip
"and" — clamp strong at distance of 3-7 mm (0.12 – 0.27 inches) from the hose end.
«b» — 20-30 mm (0.79 – 1.18 inches)
|
|
|
By means of the following type of a pipe insert a hose to its peripheral projection, as shown.
1 — a hose
2 — a pipe
3 — a clip
"and" — clamp strong at distance of 3-7 mm (0.12 – 0.27 inches) from the hose end.
«b» — 20-30 mm (0.79 – 1.18 inches)
|
|
|
By means of the bent pipe insert a hose to its bent part or until the pipe will not enter into a hose on 20-30 mm (0.79 – 1.18 inches). |
|
|
By means of a direct pipe insert a hose until the pipe will not enter into a hose on 20-30 mm (0.79 – 1.18 inches).
1 — a hose
2 — a pipe
3 — a clip
"and" — clamp strong at distance of 3-7 mm (0.12 – 0.27 inches) from the hose end.
«b» — 20-30 mm (0.79 – 1.18 inches)
|
|
|
