Suzuki Grandee of Wetar
+ General information
+ Maintenance and greasing
+ Heater, ventilation and conditioner
+ Steering
+ Suspension bracket
+ Wheels and tires
+ Forward driving shaft/bearing of a shaft. Oil epiploon
+ Driveshafts
+ Brake system
+ Engines
+ Fuel system
+ ignition System
+ start System
+ release System
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. Immobilizer
- Electric equipment
- Body electric equipment
+ Main description of the control unit body electronics
- Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (KDN)
Cleaning of a diagnostic code of malfunction (KDN)
Table of a diagnostic code of malfunction (KDN)
Scanner information
Terms and the formulations used in the scanner
The table of signals on the SUZUKI scanner exit in a test mode
+ General description
+ lighting System
+ electric equipment System
+ Tools/information for drivers
|
Codes of diagnostics of malfunctions
Check of a diagnostic code of malfunctions (KDN)
With SUZUKI scanner use
|
|
- To prepare the SUZUKI scanner.
|
|
- At the switched-off ignition to attach the device to the socket of a data link (efficiency) (1) being under the dashboard from a chair of the driver. Additional device (And): SUZUKI scanner.
|
- Include ignition.
- Read the diagnostic code of malfunction represented on the display of the SUZUKI scanner and unpack it or write down.
- For additional information see. Directory of the mechanic.
- If information transfer process between the control unit of body electronics and the SUZUKI scanner is impossible, check, whether this process with the control unit on other car is carried out.
- If information transfer process in this case is carried out, the SUZUKI scanner is in good repair. Then check the socket of a data link and the consecutive chain being in the car from which process of information transfer it was not possible to carry out.
- After completion of check, switch off ignition and disconnect the SUZUKI scanner from the data link socket.
|
|
Without SUZUKI scanner use
|
|
|
|
- Check that with inclusion of ignition the Hours/speed display turned on also.
|
- Using a repair wire (2), earth contact of the diagnostic switchboard in a place of control connection (3).
- At the included ignition and the idle engine, read KDN represented on the Hours/speed display. Find compliance in the Table of a diagnostic code of malfunction (KDN).
- After check will be finished, switch off ignition and disconnect a repair wire from a place of control connection.
|
|
2 — a repair wire
3 — control connection
4 — "mass" of the case
5 — an air inlet fragment |
|
|
|
|
